NCE Microsoft 365 and Software - CONNECT 23.0 Release Notes

Introduction

This document describes the new features and known limitations of NCE Microsoft 365 and Software - CONNECT v23.0:

New Features

• Dynamic validation for change orders is now supported.

• Ability to set the Auto-Renew status in purchase requests.

• Customers can now obtain a GDAP authorization request URL based on the roles provided by Distributors. Such request URL will be sent by email to customers once the purchase request is approved. Additionally, customers with an active subscription will be able to check if there are roles pending approval by clicking the Approve Partner Roles button available in UX1. If an approval is necessary, they will be redirected to Microsoft Admin Portal where they will be able to approve the request.

  
  For additional information, refer to the following articles:

  • Managing Role Assignment for GDAP Relationship Requests

  • Requesting a Granular Admin Relationship with Customers

  • Using the Microsoft Extension Service to Configure the GDAP Request Email Template

Fixed Issues

• When co-terming subscriptions, the request will no longer be failed when a date does not match the date of any other existing subscriptions. In such case, the request will be rescheduled for one hour later.

Known Limitations

• NCE Microsoft 365 to Non-Qualified Commercial Customers: Changing the NCE order billing cycle is not supported by CloudBlue. This has been added to CloudBlue's roadmap and can be tracked with the following Id: MAP-701.

• NCE Microsoft 365 to Non-Qualified Commercial Customers: Downsizing or changing the billing cycle in upgrades is not supported by CloudBlue. This has been added to CloudBlue's roadmap and can be tracked with the following Id: MAP-701.

• All Microsoft User-Based Products: End-User Management is not supported by CloudBlue. This has been added to CloudBlue's roadmap and can be tracked with the following Id: MAP-715.