Installing DNS Server on Hardware Node

1. Register a hardware node that meets the above requirements. Refer to the Registering Linux-based Hardware Node section.

2. Install the DNS package:

   • If you want BIND DNS, install the package bind9 (type: service) on the hardware node. Refer to the Installing PPM Packages section.
   • If you want PowerDNS DNS, refer to Preparing PowerDNS Server section.

   Note: bind9 package requires the bind rpm installed on the hardware node.

3. Set up IPv6 addresses support. Refer to the Red Hat documentation set. As soon as you set up IPv6 addresses, the BIND DNS server automatically starts working with the IPv6 addresses.